D-Link DES-3550 - Access Authentication Control

DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
129
SNMP settings are configured using the menus located on the SNMP V3 folder of the web
manager. Workstations on the network that are allowed SNMP privileged access to the Switch
can be restricted with the Management Station IP Address menu.
SNMP User Table
The SNMP User Table displays all of the SNMP User’s currently configured on the Switch.
In the SNMP V3 folder, click on the SNMP User Table link. This will open the SNMP User
Table, as shown below.
Figure 7- 20. SNMP User Table
To delete an existing SNMP User Table entry, click the below the Delete heading
corresponding to the entry you wish to delete.
To display the detailed entry for a given user, click on the hyperlinked
User Name
. This will
open the SNMP User Table Display page, as shown below.
Figure 7- 21. SNMP User Table Display
The following parameters are displayed:
Parameter Description
User Name
An alphanumeric string of up to 32 characters. This is used to identify the
SNMP users.
Group Name
This name is used to specify the SNMP group created can request SNMP
messages.
SNMP Version
V1
– Indicates that SNMP version 1 will be used.
V2
– Indicates that SNMP version 2 will be used.
V3 – Indicates that SNMP version 3 will be used.