DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
73
The following parameters can be set or are displayed:
Parameter Description
From/To
A consecutive group of ports may be configured starting with the selected
port.
Type
This drop-down menu allows you to select between RX (receive), TX
(transmit), and Both. This setting will determine whether the bandwidth
ceiling is applied to receiving, transmitting, or both receiving and transmitting
packets.
no_limit
This drop-down menu allows you to specify that the selected port will have
no bandwidth limit. Enabled disables the limit.
Rate
This field allows you to enter the data rate, in kb/s, that will be the limit for the
selected port.
Click Apply to set the Bandwidth control for the selected ports. Results of the Bandwidth
Settings will be displayed, in the Port Bandwidth Table.
SNTP Settings
Current Time Settings
To configure the time settings for the Switch, open the
Configuration
folder, then the
SNTP
folder and click on the Current Time Setting link, revealing the following screen for the user
to configure.
Figure 6- 25. Time Settings Page
The following parameters can be set or are displayed:
To Next Page
Loading...
