DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
125
Figure 7- 15. Enable Method List – Edit window
Figure 7- 16. Enable Method List – Add window
To define an Enable Login Method List, set the following parameters and click Apply:
Parameter Description
Method List Name
Enter a method list name defined by the user of up to 15 characters.
Method 1, 2, 3, 4 The user may add one, or a combination of up to four (4) of the following
authentication methods to this method list:
local_enable - Adding this parameter will require the user to be authenticated
using the local enable password database on the Switch. The local
enable password must be set by the user in the next section entitled
Local Enable Password.
none – Adding this parameter will require no authentication to access the
Switch.
tacacs – Adding this parameter will require the user to be authenticated
using the tacacs protocol from a remote tacacs server.
xtacacs – Adding this parameter will require the user to be authenticated
using the xtacacs protocol from a remote xtacacs server.
tacacs+ – Adding this parameter will require the user to be authenticated
using the tacacs protocol from a remote tacacs server.
server_group - Adding a previously configured server group will require the
user to be authenticated using a user-defined server group previously
configured on the Switch.
To Next Page
Loading...
