DES-3550 Layer 2 Fast Ethernet Switch User’s Guide
38
Figure 6- 1. IP Address Settings window.
To manually assign the Switch’s IP address, subnet mask, and default gateway address:
•
Select
Manual
from the
Get IP From
drop-down menu.
• Enter the appropriate IP address and subnet mask.
•
If you want to access the Switch from a different subnet from the one it is installed on,
enter the IP address of the gateway. If you will manage the Switch from the subnet on
which it is installed, you can leave the default address (0.0.0.0) in this field.
• If no VLANs have been previously configured on the Switch, you can use the default
VLAN Name (default). The default VLAN contains all of the switch ports as
members. If VLANs have been previously configured on the Switch, you will need to
enter the VLAN ID of the VLAN that contains the port connected to the management
station that will access the Switch. The Switch will allow management access from
stations with the same VID listed here.
To use
the
NOTE:
The Switch’s factory default IP address is 10.90.90.90 with
a subnet mask of 255.0.0.0 and a default gateway of 0.0.0.0.
To Next Page
Loading...
