D-Link DIR-608 - Page 40

36D-Link DIR-608 User Manual
Section 3 - Conguration
IPv6 Connection Type:
Choose the mode to be used by the router to the IPv6
Internet.
My IPv6 Connection is: SLACC/DHCPv6
▼
IPv6 DNS Settings
Obtain DNS server address automatically or enter a
specic DNS server address.
Obtain DNS server address
automatically
Use the following DNS
address
Primary DNS Address:
Secondary DNS Address:
LAN IPv6 Address Settings
Use this section to congure the internal network settings of
your router. If you change the LAN IPv6 Address here, you
may need to adjust your PC’s network settings to access the
network again.
Enable DHCP-PD:
☑
LAN IPv6 Address:
/64
LAN IPv6 Link-Local
Address:
xx00:yy11:zz22:123/64
SLAAC/DHCPv6
My IPv6
Connection is:
Select SLAAC/DHCPv6 if your ISP assigns your IPv6 address when
your router requests one from the ISP’s server. Some ISPs require you
to adjust settings on your side before your router can connect to the
IPv6 Internet.
IPv6 Connection Type
If you choose Use the following DNS address, please congure the following eld:
Primary DNS
Address:
Enter the primary DNS server address.
Secondary DNS
Address:
Enter the secondary DNS server address.
IPv6 DNS Settings
Select either Obtain DNS server address automatically or Use the following DNS address.
Enable DHCP-PD: Check this box to enable DHCP-PD.
LAN IPv6 Address: If you disabled DHCP-PD, enter the LAN (local) IPv6 address for the
router.
LAN IPv6 Link-
Local Address:
Displays the router’s LAN link-local address.
LAN IPv6 Address Settings