D-Link DIR-608 - Page 41

37D-Link DIR-608 User Manual
Section 3 - Conguration
SLAAC/DHCPv6 (continued)
Enable
Autoconfiguation:
Enable or disable the Automatic IPv6 Address Assignment feature.
LAN IPv6 Address: Select SLAAC+Stateless DHCP or Stateful DHCPv6.
If you choose SLAAC+Stateless DHCP, please congure the following eld:
Router
Advertisement
Lifetime:
Enter the IPv6 address lifetime (in minutes).
Address Autoconfiguration Settings
If you choose Stateful DHCPv6, please congure the following eld:
IPv6 Address
Range(Start):
Enter the starting IPv6 address for the DHCP server’s IPv6 assignment.
IPv6 Address
Range(End):
Enter the ending IPv6 address for the DHCP server’s IPv6 assignment.
Router
Advertisement
Lifetime:
Enter the IPv6 address lifetime (in seconds).
Address Autoconguration Settings
Use this section to setup IPv6 Autoconguration to assign IP
addresses to the computers on your network.
Enable Autoconguration:
☑
LAN IPv6 Address: Stateful(DHCPv6)
▼
IPv6 Address Range(Start): xxxx ::00 3
IPv6 Address Range(End):
xxxx ::00 16
Router Advertisement
Lifetime:
(second)
Address Autoconguration Settings
Use this section to setup IPv6 Autoconguration to assign IP
addresses to the computers on your network.
Enable Autoconguration:
☑
LAN IPv6 Address: SLAAC+Stateless DHCP
▼
Router Advertisement
Lifetime:
30 (minutes)