Console UI
When logged into the system, there is a prompt, type help and press Enter button. It will display
help description.
console> help
info Print system information
ifconfig Setting eth0 IP address
reset_network Reset all of network port to Manufactory setting
restart_http Restart HTTP service for management
list_port List the port number of service used
diag Print diagnostic message
dump_sysinfo Dump system information to USB
exit Exit
help Help description
console>
These options are available on the console UI:
info: Print the system information.
console> info
[System]
Product: DNS-1560-04
Name: DNS-1560-04-xxxx
Version: 1.2.3
[Network]
LAN0 => MAC 00:13:78:xx:xx:xx Addr:192.168.10.50 Mask:255.255.0.0
LAN1 => MAC 00:13:78:xx:xx:xx Addr:169.254.200.61 Mask:255.255.0.0
LAN2 => MAC 00:13:78:xx:xx:xx Addr:169.254.131.177 Mask:255.255.0.0
LAN3 => MAC 00:13:78:xx:xx:xx Addr:169.254.190.59 Mask:255.255.0.0
ifconfig: Setup the IP address of the management port.
console> ifconfig
Setting eth0 IP address usage:
ifconfig IP MASK [GATEWAY]
ifconfig DHCP
reset_network: Reset all of network ports to factory default setting.
restart_http: If the web UI is abnormal, restart HTTP service for management.
list_port: List the port number of the services.
console> list_port
[Service] [Port]
http => 80
https => 443
To Next Page
Loading...
Need help?
General
