D-Link DSL-2600U User Guide

Web Configuration
D-Link DSL-2600U User Manual
39
Click Add, the following page appears. In this page, you can create a filter rule to identify
incoming IP traffic by specifying a new filter name and at least one condition. All specified
conditions in this filter rule must comply with the rule. Click Save/Apply to save and
activate the filter.
You should select at least one WAN interface to apply this rule.
MAC Filtering Setup
Click Security > MAC Filtering, and the following page apperas.
MAC Filtering is only effective on ATM PVCs configured in Bridge mode. Forwarded
means that all MAC layer frames are forwarded except those matching with any of the
specified rules in the following table. Blocked means that all MAC layer frames are blocked
except those matching with any of the specified rules in the following table.

D-Link DSL-2600U Specifications

Power

input voltage	100V-240V
input current	0.6A
input frequency	50 Hz - 60 Hz
output voltage	12V
output current	1A

Data Transfer Rates

G.dmt full rate downstream	up to 8 Mbps
G.dmt full rate upstream	up to 1 Mbps
G.lite ADSL downstream	up to 1.5 Mbps
G.lite ADSL upstream	up to 512 Kbps
G.dmt.bis full rate downstream	up to 12 Mbps
G.dmt.bis full rate upstream	up to 1 Mbps
ADSL2+ full rate downstream	up to 24 Mbps
ADSL2+ full rate upstream	up to 1 Mbps
IEEE 802.11b wireless transfer rates	11, 5.5, 2, and 1Mbps
IEEE 802.11g wireless transfer rates	6, 9, 12, 18, 24, 36, 48, 54 Mbps

Interfaces

ADSL interface connector	RJ-11
LAN interface port	RJ-45
LAN interface standard	10/100BASE-T Ethernet