Web Configuration
D-Link DSL-2600U User Manual
65
128-bit WEP
= Network Authentication: Select the authentication mode for the selected wireless
LAN of SSID to be open or shared.
= WEP Encryption: Enable WEP Encryption.
= Encryption Strength: Click the desired Data Security level to be 128-bit.
= Current Network Key: Select one of network key that you set on the Key boxes as
default one.
= Network Key 1 to 4: Enter 13 ASCII characters or 26 hexadecimal digits for 128-bit
encryption keys to fill out WEP keys box. The system allows you to type in 4 kinds of
the WEP key.
Click Save/Apply to save the wireless security options and make the modification effect.
802.1x Authentication
= Network Authentication: Select the authentication mode for the selected wireless
LAN of SSID to be 802.1x.
= Radius Server IP Address: Enter the IP Address of the authentication server.
= Radius Port: Enter the port number of the authentication server. The default port
number is 1812.
= Radius Key: Enter the same key as the Radius server’s.
= WEP Encryption: Enable WEP Encryption. This is default
= Encryption Strength: click the desired Data Security level to be 64-bit or 128-bit.
= Current Network Key: Select one of network key that you set on the Key boxes as
default one.
= Network Key 1 to 4: Enter 5 ASCII characters or 10 hexadecimal digits for 64-bit
encryption keys or enter 13 ASCII characters or 26 hexadecimal digits for 128-bit
encryption keys to fill out WEP keys box. The system allows you to type in 4 kinds of
the WEP key.
Click Save/Apply to save the wireless security options and make the modification effect.
To Next Page
Loading...
