D-Link DSL-2600U - Page 69

Web Configuration
D-Link DSL-2600U User Manual
66
WPA Authentication
= Network Authentication: Select the authentication mode for the selected wireless
LAN of SSID to be WPA.
= WPA Group Rekey Interval: Specifies the timer the WPA key must change. If the
value set 0, no need to change. The change is done automatically between the
server and the client.
= Radius Server IP Adress: Enter the IP Address of the authentication server.
= Radius Port: Enter the port number of the authentication server. The default port
number is 1812.
= Radius Key: Enter the same key as the Radius server’s.
= WPA Encryption: Select TKIP, AES or TKIP + AES. The TKIP is default. The TKIP +
AES encryption mode means AP auto adjust to use TKIP or AES according to
wireless clients.
Click Save/Apply to save the wireless security options and make the modification effect.
WPA2 Authentication
= Network Authentication: Select the authentication mode for the selected wireless
LAN of SSID to be WPA2.
= WPA2 Preauthentication: Selec Enable or Disenable.
= Network Re-auth Interval: Specifies the timer of re-authentication between the
server and the client.
= WPA Group Rekey Interval: Specifies the timer the WPA key must change. If the
value set 0, no need to change. The change is done automatically between the
server and the client.
= RADIUS Server IP Adress: Enter the IP Address of the authentication server.
= RADIUS Port: Enter the port number of the authentication server. The default port
number is 1812.
= RADIUS Key: Enter the same key as the Radius server’s.
= WPA Encryption: Select TKIP, AES or TKIP + AES. The AES is default. The TKIP +
AES encryption mode means AP auto adjust to use TKIP or AES according to
wireless clients.
Click Save/Apply to save the wireless security options and make the modification effect.