DVG-5402G/GF Wireless AC1200 MU-MIMO Dual Band
Gigabit Router with Fiber WAN Port, 3G/LTE Support, 2 FXS
Ports, and USB Port
User Manual
Configuring via Web-based Interface
VPN
In this menu you can configure VPN connections based on IPsec/GRE/EoGRE protocols.
IPsec
On the VPN / IPsec page, you can configure VPN tunnels based on IPsec protocol.
IPsec is a protocol suite for securing IP communications.
Figure 108. The VPN / IPsec page.
To allow IPsec tunnels, move the Enable switch to the right. Upon that the Tunnels and Status
sections and the Logging level drop-down list are displayed on the page.
In the Status section, the current state of an existing tunnel is displayed.
From the Logging level drop-down list, select a detail level of messages recorded to the system
log or leave the value specified by default. The Basic value is recommended to establish an IPsec
tunnel faster. To view the log, go to the System / Log page (see the Log section, page 285).
Page 131 of 311
To Next Page
Loading...
Need help?
General
