DVG-5402G/GF Wireless AC1200 MU-MIMO Dual Band
Gigabit Router with Fiber WAN Port, 3G/LTE Support, 2 FXS
Ports, and USB Port
User Manual
Configuring via Web-based Interface
CHAPTER 4. CONFIGURING VIA WEB-BASED
INTERFACE
Initial Configuration Wizard
To start the Initial Configuration Wizard, go to the Initial Configuration section. On the opened
page, click the OK button and wait until the factory default settings are restored.
Figure 29. Restoring the default settings in the Wizard.
If you perform initial configuration of the router via Wi-Fi connection, please make sure that you
are connected to the wireless network of DVG-5402G/GF (see the WLAN name (SSID) on the
barcode label on the bottom panel of the device) and click the NEXT button.
Figure 30. Checking connection to the wireless network.
Click the START button.
Figure 31. Starting the Wizard.
Page 50 of 311
To Next Page
Loading...
