D-Link DVG-5402G

DVG-5402G/GF Wireless AC1200 MU-MIMO Dual Band
Gigabit Router with Fiber WAN Port, 3G/LTE Support, 2 FXS
Ports, and USB Port
User Manual
Configuring via Web-based Interface
You can specify the following parameters:
Parameter Description
Enable
Move the switch to the right to enable the tunnel.
Move the switch to the left to disable the tunnel.
General Settings
IP version
An IP version.
Dynamic IPsec
Move the switch to the right to allow a remote host with any public IP
address to connect to the router via IPsec protocol. Such a setting can
be specified for one IPsec tunnel only. Connection requests via this
tunnel can be sent by a remote host only.
Type
Select an identification method for the remote host (router) from the
drop-down list.
• Address: The remote host is identified by its IP address.
• FQDN: The remote host is identified by its domain name.
The drop-down list is displayed if the Dynamic IPsec switch is
moved to the left.
Remote host
Enter the remote subnet VPN gateway IP address if the Address
value is selected from the Type drop-down list.
Enter the remote subnet VPN gateway domain name if the FQDN
value is selected from the Type drop-down list.
The field is available for editing if the Dynamic IPsec switch is
moved to the left.
Identifier value
Specify a unique name of the tunnel.
Pre-shared key
A PSK key for mutual authentication of the parties. Click the Show
icon ( ) to display the entered key.
Local WAN
A WAN connection through which the tunnel will pass. Select a value
from the drop-down list.
• Interface: When this value is selected, the Interface drop-
down list is displayed. Select an existing WAN connection
from the list.
• Default gateway: When this value is selected, the router uses
the default WAN connection.
Page 133 of 311