DVG-5402G/GF Wireless AC1200 MU-MIMO Dual Band
Gigabit Router with Fiber WAN Port, 3G/LTE Support, 2 FXS
Ports, and USB Port
User Manual
Configuring via Web-based Interface
Parameter Description
Session Control
Enable session control
Move the switch to the right to enable session control. Upon that you
will be able to manage voice sessions during a call with the help of
the FLASH key on your phone. (The function should be supported
by your ISP).
Transfer code
Feature code for transferring a call to another phone.
Advanced management
Move the switch to the right to use combination of the FLASH key
and keys of the phone in order to organize three-party calls, manage
sessions and calls.
By default, each action is assigned to a certain key of the phone set.
To change this value, in the line corresponding to the action, select
the needed value from the drop-down list.
Use of FLASH key
• The function is enabled. The phone connected to this line has
an incoming call in the standby mode and an outgoing call in
the talk mode. It's needed to press the FLASH key, hear the
dial tone, and then press the key corresponding to your
action.
• The function is not enabled. The phone connected to this line
has an incoming call in the standby mode and an outgoing
call in the talk mode. It's needed:
◦ to press the FLASH key in order to put the second call
on hold and continue the first call,
◦ to hang up the receiver in order to end both calls and
connect the first and second speakers to each other.
Attended transfer
Move the switch to the right if you want to transfer calls when a
called party’s receiver is lifted.
Alert transfer
Move the switch to the right if you want to transfer calls when a dial
tone is heard.
Hotline
Enable hotline
Move the switch to the right to make the phone connected to this
line dial the number specified in the Number field after the receiver
is lifted.
Page 238 of 311
To Next Page
Loading...
Need help?
General
