D-Link DVG-5402G

DVG-5402G/GF Wireless AC1200 MU-MIMO Dual Band
Gigabit Router with Fiber WAN Port, 3G/LTE Support, 2 FXS
Ports, and USB Port
User Manual
Configuring via Web-based Interface
Parameter Description
T.38
Enable T.38 support
Move the switch to the right to allow support of the T.38 protocol. If
the switch is moved to the right, the Port field, the Fax/Modem
determination drop-down list, and the Enable custom
parameters switch are displayed on the page.
Port
The router's port for data transfer via T.38.
Fax/Modem
determination
From the drop-down list, select a mode of fax/modem signal
detection.
Enable custom
parameters
Move the switch to the right to specify additional parameters for
T.38 protocol. Upon that the Custom Parameters T.38 section is
displayed on the page.
Custom Parameters T.38
Maximal buffer
The maximum buffer size (in bytes) for data received by the router.
Rate management (TCF)
From the drop-down list, select a method for facsimile data transfer
rate management: Local or Network.
Maximal rate
From the drop-down list, select the maximum rate for facsimile data
receipt/transfer (in bauds).
Error correction mode
Move the switch to the right to enable the error correction mode.
When the switch is moved to the right, the ECC signal and ECC
data fields are available for editing.
Enable spoofing
Move the switch to the right to let the router simulate facsimile data
receipt/transfer in case of delays.
Duplicate number
Specify the number of packet duplications.
Page 247 of 311