D-Link DVG-5402G

DVG-5402G/GF Wireless AC1200 MU-MIMO Dual Band
Gigabit Router with Fiber WAN Port, 3G/LTE Support, 2 FXS
Ports, and USB Port
User Manual
Configuring via Web-based Interface
Figure 79. The page for creating a new PPTP connection. The IPv4 section.
Parameter Description
Obtain DNS server
addresses
automatically
Move the switch to the right to configure automatic assignment of
DNS server addresses. Upon that the Primary DNS and
Secondary DNS fields are not available for editing.
Primary DNS/
Secondary DNS
Enter addresses of the primary and secondary DNS servers in the
relevant fields.
Figure 80. The page for creating a new L2TP over IPsec connection. The IPsec section.
!
Setting for both parties which establish the tunnel should be the same.
Parameter Description
IPsec (for the L2TP over IPsec type)
Pre-shared key
A key for mutual authentication of the parties. Click the Show icon
( ) to display the entered key.
Enable PFS
Move the switch to the right to enable the PFS option (Perfect
Forward Secrecy). If the switch is moved to the right, a new
encryption key exchange will be used upon establishing the IPsec
tunnel. This option enhances the security level of data transfer, but
increases the load on DVG-5402G/GF.
Specify connection
port
Move the switch to the right to change the port used for data
exchange with the other party enter the needed value in the Port
filed displayed. By default, the value 1701 is specified.
When all needed settings are configured, click the APPLY button.
Page 99 of 311