D-Link DWR-932C - Add IP Filter

47D-Link DWR-932C User Manual
Section 3 - Conguration
If you selected Add New IP Filter:
Add IP Filter
Protocol
Source IP
Source Port Number
Dest IP
Destination Port
Number
Select the protocol for ports that you want to allow or
deny access to. Choose between TC P, UDP or ICMP
or all of the above.
Enter the source IP address that you wish to lter.
Click the toggle if you wish enter a single port or a
range of ports that you wish to apply the changes to.
Separate port numbers with a comma.
Type in the destination IP address.
Click the toggle if you wish enter a single port or a
range of ports that you wish to apply the changes to.
Separate port numbers with a comma.