D-Link DWR-932C User Manual

78D-Link DWR-932C User Manual
Appendix B - Networking Basics
Networking Basics
Check your IP address
After you install your new D-Link adapter, by default, the TCP/IP settings should be set to obtain an IP address from a DHCP server (i.e. wireless
router) automatically. To verify your IP address, please follow the steps below.
Click on Start > Run. In the run box type cmd and click OK.
(Windows
®
Vista
™
users type cmd in the Start Search box.)
At the prompt, type ipcong and press Enter.
This will display the IP address, subnet mask, and the default
gateway of your adapter.
If the address is 0.0.0.0, check your adapter installation, security settings, and the settings on your router. Some rewall software programs may
block a DHCP request on newly installed adapters.

D-Link DWR-932C Specifications

General

Model	DWR-932C
Category	Wireless Router
Frequency Band	2.4 GHz
SIM Support	Yes
Battery Capacity	2000 mAh
Security	WPA/WPA2
Wireless Speed	Up to 150 Mbps
Cellular Technology	4G LTE
Antennas	Internal
Wireless Standard	802.11n
Interfaces	Micro-USB
Weight	77 g