D-Link Nuclias Connect DAP-2622

D-Link DAP-2622 User Manual
16
Wireless Band:
Mode:
Network Name (SSID):
Auto Channel Selection:
Channel:
Channel Width:
AP MAC Address:
Select either 2.4GHz or 5GHz from the drop-down
menu.
WDS is selected from the drop-down menu.
Service Set Identier (SSID) is the name designated
for a specic wireless local area network (WLAN). The
SSID’s factory default setting is dlink. The SSID can
be easily changed to connect to an existing wireless
network or to establish a new wireless network.
Enabling this feature automatically selects
the channel that will provide the best wireless
performance. This feature is not supported in WDS
mode.
All devices on the network must share the same
channel. To change the channel, use the drop-down
menu to make the desired selection.
Click the drop-down menu to select 20 MHz, Auto
20/40 MHz or Auto 20/40/80 MHz. Select 20 MHz
if you are not using any 802.11n wireless clients.
Auto 20/40 MHz allows you to connect to both
802.11n and 802.11b/g or 802.11a wireless devices
on your network.
Enter the MAC address of the AP on your network
that will serve as a bridge to wirelessly connect
multiple networks.
WDS Mode