D-Link Nuclias Connect DAP-2622

D-Link DAP-2622 User Manual
26
Performance
On the Performance Settings page, you can congure more advanced settings concerning the wireless signal and hosting.
Wireless Band:
Wireless:
Wireless Mode:
Data Rate*:
Beacon Interval (40-500):
DTIM Interval (1-15):
Select either 2.4GHz or 5GHz.
Use the drop-down menu to turn the wireless function on or o.
Click the drop-down menu to select the wireless mode. 2.4GHz band
supports: Mixed 802.11b, 802.11g, 802.11n; Mixed 802.11b,
802.11g; and 802.11n Only. 5GHz band supports: Mixed 802.11n,
802.11a; 802.11a Only; 802.11n Only; and Mixed 802.11ac.
Please note that when backwards compatibility is enabled for legacy
(802.11a/g/b) clients, degradation of 802.11n wireless performance
is expected.
When Wireless Mode is set to Mixed 802.11b, 802.11g (for 2.4GHz)
and 802.11a Only (for 5GHz), click the drop-down menu to indicate
the base transfer rate of wireless adapters on the wireless LAN. The
AP will adjust the base transfer rate depending on the base rate of
the connected device. If there are obstacles or interference, the AP
will derate the transfer rate.
Beacons are packets sent by an access point to synchronize a
wireless network. Specify a value in milliseconds. The default (100)
is recommended. Setting a higher beacon interval can help to save
the power of wireless clients, while setting a lower one can help a
wireless client connect to an access point faster.
Select a Delivery Trac Indication Message setting between 1 and 15. 1 is the default setting. DTIM is a countdown informing
clients of the next window for listening to broadcast and multicast messages.