xStack
®
DGS-3426G Layer 2 Gigabit Ethernet Managed Switch
249
authenticated host and the host will be moved back to the unauthenticated state. Enter a
value between 1 and 1440 minutes. A value of Infinite indicates the Idle state of the
authenticated host on the port will never be checked. The default setting is Infinite.
Block Time (0-300
sec)
This parameter specifies the period of time a host will keep in a blocked state after it fails
to authenticate. Enter a value between 0 and 300 seconds. The default setting is 0
seconds.
Click Apply to implement changes made.
WAC User Account
This window is used to enable and configure Web-based Access Control User Account Settings on the Switch.
To view this window, click Security > Web Authentication > WAC User Account, as shown below:
Figure 6 - 30 WAC User Account window
To create a new user account click Add, the following window will be displayed for the user to configure. To edit an entry click
on the corresponding Modify button as shown below:
Figure 6 - 31 WAC User Account – Add window
To Next Page
Loading...
