L. Crank Case Cover/Kick Starter/Continuously Variable Transmission
● Check the driven face assembly for wear or
damage.
● Measure the outer diameter of the driven face.
Service limit: 37.94mm(1.491in)
● Check the movable driven face for wear or
damage.
● Measure the inner diameter of movable driven
face.
Service limit: 38.06mm(1.496in)
● Check the guide globe for wear or damage.
● Check the oil seal for wear, damage or other
defects.
Driven Face Assembly
● Assemble the outer bearing to the movable
driven face.
NOTE
● Insert the circlip into the groove.
● Fill the grease into all bearing grooves.
Grease application: 9.0-9.5g
7-15
Assemble the bearing so that the sealed edge
faces outward.
● Assemble inner bearing.
NOTE
Tool: - Bearing driver attachment
- Driver pilot
Assemble the bearing so that the sealed edge
faces outward.
Outer bearing
Inner bearing
Movable face
Guide pin globe
To Next Page
Loading...
