Operation Section
-61-
Changing LP-Gas Tanks
WARNING
Only trained, authorized personnel should fill or
exchange LP-Gas tanks.
Personnel engaged in filling of LP-Gas containers
should wear protective clothing such as face shield,
long sleeves and gauntlet gloves.
Do not refuel or store LP-Gas powered lift trucks
near any underground entrance, elevator shafts or
any other place where LP-Gas could collect in a
pocket causing a potentially dangerous condition.
Examine all LP-Gas containers before filling and
again before reuse, for damage to various valves,
liquid gauge, fittings and hand valve wheels.
All defective or damaged LP-Gas containers must
be removed from service.
Explosive fumes may be present during refueling.
Do not smoke in refueling areas.
Lift truck should be refueled only at designated safe
locations. Safe outdoor locations are preferable to
indoor locations.
Stop the engine and get off the lift truck during
refueling.
The careless handling of LP-Gas containers can
result in a serious accident.
Use extreme care when transporting containers to
prevent damage to them.
1. Park the lift truck on level ground, with the parking
brake applied, the transmission in NEUTRAL, the
forks lowered and the engine running at low idle.
2. Close the fuel inlet valve at the LP - Gas tank. Run
the engine until it stops, then turn off the ignition
switch and the electrical disconnect switch (if
equipped).
3. Disconnect the fuel supply line.
4. Loosen the retaining clamps and remove the tank.
5. Check the mounting to be sure the locating pin
(dowel) is not missing or broken.
NOTICE
If the location pin (dowel) is missing or broken, be
sure the pin is replaced.
To Next Page
Loading...
Need help?
General
