Pilot's Operating Handbook
Section 8
Handling, servicing and maintenance
Edition 0 - March 05, 2019
Rev. 3
Page 8.9.5
f) Release locking handle (21) to lock the seat.
▲ WARNING ▲
Verify that lock (22) and all pads (23) are engaged and locked into
rails, trying to move seat forward and backward.
▲
g) Install backrest bottom upholstery (25).
● NOTE ●
Adjust it properly; make sure not to obstruct deflector (34) outlet.
●
h) Slide properly the carpet under the seat.
i) Remove protective covers.
H - Final operations
1) If removed, install cabin central carpet suited to the intended use.
● NOTE ●
Slide properly the carpet under doorstep.
●
2) If necessary, remove the baggage compartment partition net and
install the small or large cargo net - refer to section 7.
3) Make sure the work area is clean and free from debris.
4) Determine weight and balance - refer to section 6.
2 -- Conversion of 4-seat accommodation into 6-seat accommodation - see
figures 8.9.1, 8.9.2, 8.9.3 and 8.9.4
A - Tools and consumable materials
- Seat protective covers
B - Preparation
1) Make sure the SOURCE selector is set to OFF and the crash lever is
down.
2) If installed, remove the cargo net.
3) Remove intermediate seats – refer to paragraph 1.D.
4) Remove the deflectors (34) maintained with Velcro-type strap.
5) If necessary, remove the cabin central carpet.
To Next Page
