User’s Manual
7
3 Configuration and Management
Device Connection 3.1
Before configuration, connect the Router and the PC with the network cable or Wi-Fi. See
Figure 3-1.
Connect with network cable:
Connect one end of the network cable to the Local Network (LAN) port of the Router, and
another end of the network cable to the Ethernet port of the PC.
Connect with Wi-Fi:
The default SSID of the Router is "Dahua Wireless", and password is not required.
Device connection Figure 3-1
Login 3.2
Before you configure the Router, make sure that:
The Router is connected to the PC.
The network of the PC is set to automatic access mode.
Open the browser, enter IP address of the Router (the default IP is 192.168.1.110) and Step 1
then press Enter key.
Enter the login account and password. Step 2
The account is admin and password is admin by default.
It is recommended to change the user name and password after first login.
The password must consist of 8 to 32 non-blank characters and contain at least
two types of characters among upper case, lower case, number, and special
character (excluding ' " ; : &).
You can also reset password in Administratio > Management , refer to 3.12.1.1
Router Password.
To Next Page
Loading...