User’s Manual
27
Bridged: Bridge to the Router, normally select this option.
Unbridged: No bridge to the Router, you need to manually configure
IP address and subnet mask.
Click Save to save the configuration. Step 4
Click Apply Settings to apply the configuration. Step 5
(Optional) Click Cancel Changes to cancel the configuration. Step 6
3.4.1.2 Virtual Interfaces
Log in to the web interface of the Router. Step 1
In the left navigation menu, select Wireless > Basic Settings.
Step 2
In Virtual Interfaces section, click Add. Step 3
Add virtual interface Figure 3-18
Set parameters. For details, see Table 3-13. Step 4
AP Isolation：Isolate all wireless client devices so that they can only access fixed
network connected by AP.
(Optional) Click Remove to delete the virtual interface. Step 5
Click Save to save the configuration. Step 6
Click Apply Settings to apply the configuration. Step 7
3.4.2 Wireless Security
You can configure the security of your wireless network. There are 7 wireless security modes
are available. And the security mode is disabled by default.
To configure the security of the physical interface and the created virtual interfaces:
Log in to the web interface of the Router. Step 1
In the left navigation menu, select Wireless > Wireless Security. Step 2
In Physical Interface and Virtual Interfaces section, select a security mode, and then Step 3
configure security parameters.
To Next Page
Loading...