Dahua DH-WM4700-O - MAC Address Clone; Advanced Router

User’s Manual
19
3.3.3 MAC Address Clone
Some ISPs might require you to register your MAC address. If you do not want to re-register
your MAC address, you can clone the MAC address of the Router to your MAC address
registered with ISP.
Log in to the web interface of the Router. Step 1
In the left navigation menu, select Setup > MAC Address Clone. Step 2
In MAC Clone section, select Enable. Step 3
MAC Clone can clone three parts: LAN MAC Clone, WAN MAC Clone, and Wireless
MAC Clone.
 The MAC address is 48-bit and cannot be set as a multicast address, that is, the
first byte should be even.
 The MAC address of bridge br0 is determined by the smaller value of wireless
MAC address and LAN MAC address.
Enable MAC Clone Figure 3-10
(Optional) Click Get Current PC MAC Address to get your current PC MAC address. Step 4
Click Save to save the configuration. Step 5
Click Apply Settings to apply the configuration. Step 6
(Optional) Click Cancel Changes to cancel the configuration. Step 7
3.3.4 Advanced Router
You can set the operating mode and static routing.
Operating Mode
Log in to the web interface of the Router. Step 1
In the left navigation menu, select Setup > Advanced Routing. Step 2