Dahua DH-WM4700-O - System Log

User’s Manual
31
Enable SNMP Figure 3-22
Table 3-16 Description of SNMP parameters
Parameter
Description
Location
Set the location identification of the device.
Contact
The contact information and name of SNMP.
Name
RO Community
SNMP RO community name, the default is public, Only with read
permission.
RW Community
SNMP RW community name, the default is private, with read and write
permissions.
Click Save to save the configuration. Step 4
Click Apply Settings to apply the configuration. Step 5
(Optional) Click Cancel Changes to cancel the configuration. Step 6
3.5.4 System Log
You can enable system log to capture system messages. By default the system log will be
collected in the local file /var/log/messages.
Log in to the web interface of the Router. Step 1
In the left navigation menu, click Services. Step 2
In SNMP section, enable Syslogd, and then select Syslog Out Mode. Step 3
The following system output modes are available:
 Console: Outputs the log information to console port.
 Web: Outputs the log information to Web.
Net is not supported currently.
Click Save to save the configuration. Step 4
Click Apply Settings to apply the configuration. Step 5
(Optional) Click Cancel Changes to cancel the configuration. Step 6