User’s Manual
51
In the left navigation menu, select Access Restrictions > MAC Filter. Step 2
Enable MAC filter. Step 3
MAC filter Figure 3-42
Select a policy. Step 4
Discard packets conform to the following rules: Only discard the matching
MAC addresses in the list.
Accept only the data packets conform to the following rules: Only accept the
matching MAC addresses in the list.
Enter MAC address in Add Filter Rule MAC box, and then click Add. Step 5
Click Save to save the configuration. Step 6
Click Apply Settings to apply the configuration. Step 7
(Optional) Click Cancel Changes to cancel the configuration. Step 8
3.8.4 Packet Filter
With packet filter, you can prevent certain packets from entering to the Internet through the
Router or prevent certain Internet packets from getting into the local network.
Log in to the web interface of the Router. Step 1
In the left navigation menu, select Access Restrictions > Packet Filter. Step 2
Enable packet filter. Step 3
To Next Page
Loading...