Dahua DH-WM4700-O - Ipsec

User’s Manual
41
Parameter
Description
Policy based Routing
Customize the routing policy.
PKCS12 Key
Private key format, set as needed.
Static Key
Set as needed.
Click Save to save the configuration. Step 4
Click Apply Settings to apply the configuration. Step 5
(Optional) Click Cancel Changes to cancel the configuration. Step 6
3.6.4 IPSEC
3.6.4.1 Global Settings
Log in to the web interface of the Router. Step 1
In the left navigation menu, select VPN > IPSEC. Step 2
In Global settings section, select Enable NAT-Traversal and Debug Level. Step 3
Global settings Figure 3-30
Click Save to save the configuration. Step 4
3.6.4.2 Connection Status and Control
You can view IPSEC connection and status of the Router on IPSEC page.
Log in to the web interface of the Router. Step 1
In the left navigation menu, select VPN > IPSEC. Step 2
In Connection status and control section, click Add. Step 3
Configure IPSEC type. Step 4
 Type: Supports Net-to-Net Virtual Private Network and Host-to-Host Virtual Private
Network (RoadWarrior).
 IPSEC role: Supports Client and Server.
Connection type Figure 3-31
Configure basic address information of the tunnel. Step 5