User’s Manual
22
VLAN Figure 3-12
Click Save to save the configuration. Step 4
Click Apply Settings to apply the configuration. Step 5
(Optional) Click Cancel Changes to cancel the configuration. Step 6
3.3.6 Networking
You can create bridges, assign ports to bridges, view the current bridging list, configure ports
and manage DHCPD servers.
3.3.6.1 Bridging
Create Bridge
Log in to the web interface of the Router. Step 1
In the left navigation menu, select Setup > Networking. Step 2
In Create Bridge section, click Add. Step 3
Enter bridge name, set other bridge parameters, and then click Save. Step 4
STP: Whether to enable Spanning Tree Protocol.
Prio: Indicates the priority level of STP. The smaller the number, the higher the
priority.
MTU: Maximum Transmission Unit, the default value is 1500.
To Next Page
Loading...