User’s Manual
23
Create bridge Figure 3-13
The smaller the number after the bridge, the higher the priority. For example, the
priority of Bridge 0 is higher than that of Bridge 1.
Click Delete, you can delete the corresponding bridge.
Enter IP address and subnet mask of the bridge. Step 5
Click Apply Settings to add a bridge. Step 6
(Optional) Click Cancel Changes to cancel the adding. Step 7
Assign to Bridge
You can assign any valid interface to a network bridge. For example, assign ra0 interface
(wireless interface) to br1 bridge.
Log in to the web interface of the Router. Step 1
In the left navigation menu, select Setup > Networking. Step 2
In Assign to Bridge section, click Add. Step 3
Select bridge, interface and set priority. Step 4
Prio means priority level, works if multiple ports are within the same bridge. The smaller
the number, the higher the priority.
This bridge assignment is only used for LAN ports, WAN ports are not supported.
Assign to bridge Figure 3-14
Click Save to save the configuration. Step 5
Click Apply Settings to apply the configuration. Step 6
In Current Bridging Table section, you can view the bridge list and binding
relationships between bridges and LAN ports after successful assignment.
(Optional) Click Cancel Changes to cancel the configuration. Step 7
To Next Page
Loading...