User’s Manual
24
3.3.6.2 Port Setup
You can set the properties of each port. Take ra0 port as an example.
Log in to the web interface of the Router. Step 1
In the left navigation menu, select Setup > Networking. Step 2
In Port Setup section, select Unbridged next to Network Configuration ra0. Step 3
Set properties of the selected port. Step 4
Port setup Figure 3-15
Table 3-12 Parameter description of port setup
Maximum transmission unit, 1500 bytes by default.
Set whether to enable multicast forwarding.
Set whether to enable Masquerade/NAT.
Set IP address of selected port. It cannot conflict with other ports or
bridges.
Set subnet mask of the selected port.
Click Save to save the configuration. Step 5
Click Apply Settings to apply the configuration. Step 6
(Optional) Click Cancel Changes to cancel the configuration. Step 7
3.3.6.3 DHCPD
You can use multiple DHCP service.
Log in to the web interface of the Router. Step 1
In the left navigation menu, select Setup > Networking. Step 2
To Next Page
Loading...