Dahua DH-WM4700-O - Page 42

User’s Manual
36
3.6.2.2 L2TP Client
Log in to the web interface of the Router. Step 1
In the left navigation menu, select VPN > L2TP. Step 2
In L2TP Client section, enable L2TP Client, and set parameters. Step 3
Enable L2TP client Figure 3-26
Table 3-20 Description of L2TP client parameters
Parameter
Description
Tunnel name
Set tunnel name.
User Name
Enter user name to log in to L2TP server.
Password
Enter password to log in to L2TP server.
Tunnel Authentication
Password
Set tunnel authentication password as needed, not recommended.
Gateway (L2TP Server)
Enter IP address or DNS name of L2TP server.
Remote Subnet
Enter the internal network of the remote L2TP server.
Remote Subnet Mask
Enter the internal subnet mask of the remote L2TP server.
MPPE Encryption
Set whether to enable MPPE encryption.
MTU
Maximum Transmission Unit.
The range is 0–1500.
MRU
Maximum Receive Unit.
The range is 0–1500.