Dahua DH-WM4700-O - Page 49

User’s Manual
43
Click Apply Settings to save the configuration. Step 9
Connection Status Figure 3-33
Table 3-25 Parameter description of connection status
Parameter
Description
Num
Connection number.
Name
The name of the IPSEC connection.
Type
Types and functions of the current IPSEC connection.
Common Name
Displays addresses and subnets of the local and peer.
Status
The state of the connection, including:
Closed: The connection did not initiate a connection request to the

peer.
Negotiating: The connection has initiated a request to the peer and

is still in the negotiation process, but the connection has not been
established.
Establish: The connection has been established and the channel

can be used.
Action
You can perform operations on the connection, including:
: Delete the connection. If the IPSEC channel is established, it

will also be removed.
: Edit the connection. After the modification, you need to reload

the connection to make the configuration take effect.
: Reconnect. This operation will remove the current channel and

request a channel establishment.
: Enabled: When the connection is enabled, the system will

initiate a channel establishment request when the system restarts or
reconnects; otherwise, the connection will not initiate a request.
3.6.4.3 Certificate Management
You can add, view, download and delete certificates.
Log in to the web interface of the Router. Step 1
In the left navigation menu, select VPN > IPSEC. Step 2
In Certificate Management section, click Add. Step 3
Select a certificate adding method. Step 4
 Import a certificate