User’s Manual
54
Ethernet Card
Select the Ethernet card. The default setting is Wire.
Mode
Network mode, including static and DHCP.
Static: It needs to manually set IP, subnet mask and gateway.
DHCP: Automatically acquire IP, at this moment IP, subnet mask and
gateway cannot be set.
MAC Address Host MAC address.
IP Version
IP version, including
and
. The IP address of both versions can
be accessed.
IP Address Device IP Address.
Subnet Mask The corresponding subnet mask of device IP address.
Default Gateway Corresponding gateway of device IP address.
Preferred DNS IP address of DNS server.
Alternate DNS Alternate IP address of DNS server.
Step 3 Click Confirm.
4.5.3.2 Connection
4.5.3.2.1 Port
You can set the connected port information, it can access device through different protocols or
config tool.
Step 1 Select Setup > Network > Connection > Port.
Figure 4-57 Port
Step 2 Configure each port value of the Camera. For more details, see Table 4-28
.
Table 4-28 Connection parameters description
Max
The maximum number of clients (such as web client and platform client) that
are allowed to access the Camera simultaneously. It is 10 by default.
Protocol communication port. It is 37777 by default.
To Next Page
Loading...
Need help?
General
