Set the naming mode of picture and storage path. Please refer to Help for
more details.
Click OK to finish configuration.
5.4.5.4 Client
In this section, you can set the parameters of offline transfer.
Select Setting > Storage > Destination > Client.
The Client interface is displayed. See Figure 5-65.
Client
Configure parameters according to actual requirement. Please refer to Table 5-32 for
more details.
Table 5-32 Client
When network is disconnected or failed, you can store the picture into local
storage card and it will automatically upload to platform server after network
resumes.
Select connection type with platform server.
IP: Connect to platform server via IP address.
MAC: Connect to platform service via MAC address.
Select server which includes server 1 and server 2.
When the type is selected as IP, then it has to fill in the server’s IP
address.
When the type is selected as MAC, then it has to fill in the server’s
MAC address.
Click OK to finish configuration.
5.4.5.5 Path
In this section, you can set picture, record naming and path.
Select Setting > Storage > Destination > Path.
The Path interface is displayed. See Figure 5-66.
To Next Page
Loading...
