Dahua Modular VTO - Modifying VTO Network Settings

20
Figure 5-4
Enter user name and password, and click “Login”. Step 7
Log in the WEB interface of the device.
 Default user name is admin.
 Password is the one set during initialization.
5.1.1.2 Modify Device Network
Modify IP address of VTO to the planned IP address.
Select “System Config> Network Config> TCP/IP”. Step 1
The system displays “TCP/IP” interface, as shown in Figure 5-5.
Figure 5-5
Enter the planned “IP Address”, “Subnet Mask” and “Default Gateway”, and click “OK”. Step 2
After modification is completed, VTO reboots automatically, while the following two
cases occur at WEB interface.
 If PC is in the planned network segment, WEB interface jumps to new IP login
interface automatically.
 If PC is not in the planned network segment, login will be failed. Please add PC to
the planned network segment and login WEB interface again.