Dahua Modular VTO - Page 74

64
Parameter
Description
Server
Name
Name of network server.
Protocol
Protocol type.
Inport
Port that
this device
needs to
map.
 When you set router mapping outer port, try to use port
within 1024~5000, avoid using well-known port 1~255
and system port 256~1023, in order to prevent conflicts.
 When there are multiple devices in the same LAN,
please plan port mapping, to prevent multiple device
mapping to one outer port.
 For port mapping in progress, please make sure
mapping port is not occupied or limited.
 TCP/UDP inports and outports must be identical, and
they cannot be modified.
Outport
Port that is
mapped on
the router.
Table 7-4
Click “OK” to save the settings. Step 5
7.5.7.3 Modify Server
Modify server mapping relation in the list.
Click . Step 1
The system displays “Add” interface, as shown in Figure 7-22.
Figure 7-22
Set parameters and refer to Table 7-4 for details. Step 2
Click “OK” to save the settings. Step 3
7.5.7.4 Delete Server
Delete server mapping relation in the list.
Click to delete mapping relation.