Page.114.
Date/Time: Set the Date/time of the Tester.
IP setting: Manually set the IP address, Sub-net Mask, Default Gateway and DNS address or select
“Dynamic allocation” to use DHCP. To test multiple network segments, click “Advanced” and then
click “Add” to enter another IP address for the Tester.
After setting an advanced IP address (refer to the photos above), the unit can test two network segments
(192.168.5.0) and (192.168.1.0).
WLAN Net: Turn WiFi off or on by pressing the “Open the wifi” button. Once WiFi is turned on, and
click connected WIFI, it will scan for wireless networks in your area.
To Next Page
Loading...