Connecting an emergency stop input device or electric energy meters
The intelligent Touch Manager can be connected with an external signal input device for stopping air conditioners in an emergency, or
with electric energy meters for calculating the electricity usage of individual air conditioners (when power distribution is enabled).
WARNING
• Be sure to perform this procedure with the power supply turned off. Not doing so may cause
an electric shock.
• Do not clamp the cables with high-current lines such as a power cable.
NOTE
• Power distribution is available for a maximum of 64 air conditioners (indoor units) per DIII-NET port.
• With 7 iTM plus adaptors, however, you can connect up to 512 indoor units.
To Next Page
Loading...
