Daikin RoCon HP - 5 Parameter Overview

5 x Parameter Overview
Daikin RoCon HP
Daikin Controller
008.1420844_13 – 02/2016
Operating instructions
37
5 Parameter Overview
5.1 For first commissioning or resetting to factory settings
The parameters listed in this section can be accessed
when the Daikin Altherma EHS(X/H) is commissioned
for
the first time or if it is fully reset.
During initial commissioning: After resetting to factory settings:
● Rotary switch setting: Info ● Resetting to factory settings.
(see chapter 3.6.12 - Possibility 3)
● Rotary swit
ch setting: Info
● Turn power supply to Daikin Altherma EHS(X/H) on.
Language
Use
St
andard Config
Yes No
Basic Configuration Boiler Function
Unmixed Circ Config
BUS ID HS
Time Master
System Config
Tab. 5-1 Parameter "Basic Configuration"