Operating instructions
38
Daikin RoCon HP
Daikin Controller
008.1420844_13 – 02/2016
5 x Parameter Overview
5.2 After first commissioning / after successful basic configuration
5.2.1 Rotary switch setting: Configuration
Setup LCD Brightness
System Power DHW LCD Illum Time
BUH s1 power Language
BUH s2 power Date
Power BIV Time
TDiff-DHW CH Keylock Function
T vbh1 max Access Rights
Equilibrium Temp RoCon U1 assign
Quite Mode Master-RoCon
AUX Fct Outdoor type
AUX time INDOOR UNIT
T-DHW 1 min HP Version
Delta-T CH Function Heating
V var HZU
T-Flow CH adj Equilibrium Func.
T-Flow Cooling adj SMART GRID
Min Pressure Mode SG
Max Pressure HT/NT Function
Set Point Pressure HT/NT Contact
Max Pressuredrop Room thermostat
Relay Test Interlink fct
MF 1 Config
Air Purge
PWM Config Max Perform Pump
Min Perform Pump
HC Configuration HC Function Sensor Config Outside Config
T-Frost Protect Outside Temp Adap Storage Config
Insulation Terminaladress Pressure Config
Screed System Config
Screed Program HC Assignment
Heating T-Outside lim day
Cooling
Start T-Out Cooling T-Outside lim night
Max T-Out Cooling Heat-Slope
DHW Configuration Circl-Pump DHW T-Flow Cooling start Room Influence
Circl-Pump Interval T-Flow Cooling max T-Room Adj
Anti-Legionella day Min T-Flow Cooling T-Flow Day
Anti-Legionella time T-Flow Cooling T-Flow Night
Anti-Legionella temp T_H/C Switch Max T-Flow
Max DHW loading Cooling Setpoint adj Min T-Flow
DHW Off Time HC Adaption
Tab. 5-2 Parameter in rotary switch setting "Configuration"
To Next Page
Loading...
