SiUS281811EA Field Setting from Remote Controller
Part 5 Field Settings and Test Operation 165
1.5.29 Direct Duct Connection
This is used when "fresh air intake kit equipped with fan" is connected. The indoor unit fan carries
out residual operation for 1 minute after the thermostat is stopped. (For the purpose of preventing
dust on the air filter from falling off.)
: Factory setting
1.5.30 Drain Pump and Humidifier Interlock Selection
This is used to interlock the humidifier with the drain pump. When water is drained out of the unit,
this setting is unnecessary.
: Factory setting
1.5.31 Individual Ventilation Setting
This is set to perform individual operation of energy recovery ventilator using the remote
controller/central unit when heat reclaim ventilation is built in.
(Switch only when heat reclaim ventilation is built in.)
: Factory setting
1.5.32 Display of Error Codes on the Remote Controller
For BRC1E series only
Error code (four digits) is displayed for limited products.
Select two-digit display if four-digit display is not preferred.
: Factory setting
Mode No. First Code No. Second Code No. Contents
15 (25) 2
01
Not equipped
02 Equipped
Mode
No.
First Code
No.
Second Code
No.
Contents
15 (25) 3
01
Not interlocked
02 Interlocked
Mode
No.
First Code
No.
Second Code
No.
Contents
15 (25) 5
01
— (Normal)
02 Individual
Mode
No.
First Code
No.
Second Code
No.
Contents
1b 4
01 —
02 Two-digit display
03 —
04
Four-digit display
To Next Page
Loading...
