2 | Components
Service manual
127
(C)(F)TXA15~50A(W)(S)(T) + (C)(F)TXA15~50B(B)(S)(T) + RXA42+50A +
RXA20~35A + RXA42+50B
Split Stylish R32
ESIE18-03C – 2020.02
▪ Measured temperature with contact thermometer: 23.1°C,
▪ Resistance value determined through temperature (using the table for type
1 thermistors):
Resistance at 23°C: 21.85kΩ,
Resistance at 24°C: 20.90kΩ,
▪ Disconnect connector and measure resistance between S600 pin 1‑2:
Measured resistance: 21.86kΩ,
▪ Measured resistance value is inside the range. R1T thermistor passes the
check.
INFORMATION
All thermistors have a resistance tolerance of 3%.
INFORMATION
In most cases, the user interface allows to monitor the thermistors.
If the measured resistance value matches the resistance determined through the
measured temperature, but the temperature for the corresponding thermistor is
NOT correct on the user interface display, replace the applicable PCB.
Does the measured resistance of the
thermistor match with the
temperature determined resistance?
Action
Yes Thermistor is OK. Return to the
troubleshooting of the specific error
and continue with the next procedure.
No Replace the specific thermistor, see
"Repair procedures"[4129].
To perform an electrical check of the specific PCB fin thermistor
Prerequisite: Stop the unit operation via the user interface.
Prerequisite: Turn OFF the respective circuit breaker.
Prerequisite: Remove the required plate work, see "2.13Plate work"[499].
1 Locate the thermistor on the appropriate PCB.
2 Measure the temperature using a contact thermometer.
INFORMATION
The thermistors may vary according to the specific unit.
3 Determine the thermistor resistance that matches the measured
temperature.
Type 1 thermistor
T °C kΩ T °C kΩ T °C kΩ T °C kΩ
–20 197.81 10 39.96 40 10.63 70 3.44
To Next Page
Loading...
