Daikin VRV Inverter K Series - Transmission between Outdoor Units; VRV System Inverter K Series

SiE-05C Outline of System
General Information Inverter K Series 7
Change in Mode of
Transmission
Between Outdoor
Units
Wiring for transmission between outdoor units is necessary for selecting cool or heat mode for several
units at once. This transmission has been changed as follows.
H Series
 Separate input and output terminals.
 Sequential start requires adaptor PC board.
 Simultaneous cool/heat selection and low noise operation require only wiring between outdoor units
and setting.
↓
K Series
 Same terminals used for input and output.
 Sequential start requires only wiring between outdoor units and setting.
 Simultaneous cool/heat selection and low noise operation require a separate adaptor for outside control
of outdoor units.
 Transmission can be conducted between a maximum of 10 units.
 Optional controllers for centralized control can be connected to a transmission line between outdoor
units.
VRV System
Inverter K Series
Outdoor unit
F1 F2 F1 F2
Indoor
-outdoor
Outdoor
-outdoor
Indoor
-outdoor
Outdoor
-outdoor
Indoor
-outdoor
Outdoor
-outdoor
To other outdoor unit
To indoor unit
Indoor unit
Individual remote controller
Central remote controller
F1 F2
F1 F2N P
F1 F2
F1 F2N P F1 F2N P F1 F2N P F1 F2N P
F1 F2N P F1 F2N P
F1 F2 F1 F2F1 F2 F1 F2
(VL002)
SI-05C.BOOK Page 7 Monday, November 6, 2000 4:13 PM
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html