EasyManua.ls Logo

Daikin VRV Inverter K Series - Applicable Wireless Remote Controller Models

Daikin VRV Inverter K Series
412 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SiE-05C Test Operation
Test Operation Inverter K Series 79
1.10.2 Applicable Wireless Remote Controller Models
Part Names and
Functions
Note: Works only for indoor unit set to have cool/heat selection permission.
Type FXYC-K FXYK-K FXYF-K FXYS-K FXYH-K FXYA-K FXYL-K
FXYLM-K
FXYM-K
Wireless remote
controller
H / P BRC7A62 BRC7A61W BRC4A62 BRC7A63W BRC7A64W BRC4A62 BRC4A62
C / O BRC7A67 BRC7A66W BRC4A64 BRC7A68W BRC7A69W BRC4A64 BRC4A64
1 Display of transmission 10 Filter sign reset button
Blinks when a signal is being sent to an indoor unit. After cleaning the filter, push to cancel the air filter cleaning time.
2 Operation mode display 11 Operation mode selector button
Displays status during operation.
Auto can be set only for cool/heat simultaneous operation
systems.
Push to switch the operation mode. Note
3 Preset temperature display 12 Timer ON/OFF button
Displays the preset temperature. Push to turn the timer on or off.
4 Display air flow / flap 13 Programming time button
Displays fixed or swing for air direction. Push to set programming time.
5 Inspection / test operation display 14 Time mode START/STOP button
When the inspection / test operation button is pushed, displays
whether the system is in the inspection or test operation mode.
Push to start or stop the timer.
6 Fan speed adjustment button 15 ON/OFF button
Each time this button is pushed, fan speed toggles between
high and low.
One push starts the system, and a second push stops the system
again.
7 Temperature control button 16 Display of fan speed
Push to set temperature. Displays set fan speed.
8 Air flow direction adjustment button 17 Display programmed time
Push to set the air flow direction to fixed or swing. Displays programmed time.
9 Inspection / test operation button 18 Battery change display
Push for inspection or test operation. Blinks to let you know it is time to replace the battery.
19 Transmitter
Transmits signals to the indoor unit.
SI-05C.BOOK Page 79 Monday, November 6, 2000 4:13 PM
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html

Table of Contents

Related product manuals