Test Operation SiE-05C
80 Test Operation Inverter K Series
Example of System
Using Wireless
Remote Controller
For control by two remote controllers, be sure to designate the indoor unit remote controller as the master.
The only combination that can’t be used is two wireless remote controllers. Transmission wiring between
the separately installed receiver unit unit and indoor unit can be up to 200 meters long.
Comparison of
Functions of Wired
and Wireless
Remote Controllers
All operation buttons (preset temperature, fan speed, timer, inspection / test operation, cool/heat
selection permission and group No. setting for centralized control) function in the same manner.
Wired remote controller Wireless remote controller
Function /display
Operation lamp Remote controller LED Receiver unit LED
ON/OFF Toggles between on and off each time the button is pushed.
Operation mode selection Selects operation mode. Cool/heat
mode cannot be switched during
changeover under control.
Selects operation mode. Cool/heat
display switches during changeover
under control.
Air flow direction setting The air flow direction is set by
adjusting with the air flow direction
adjustment button while viewing
setting position in the liquid crystal
display.
The air flow direction is set by
adjusting with the air flow direction
adjustment button while viewing the
position of the louver.
Filter sign reset Resets the filter and element cleaning
display.
Resets the filter and element cleaning
display. Displayed by optical sensor
LED.
Display “time to clean air
cleaner element” Filter sign
display
Remote controller LCD display Displayed by receiver unit LED.
Display “ventilation/cleaning” Displayed when HRV or air cleaner
unit is connected.
Ventilation/cleaning displayed by
receiver unit LED.
Defrost hot start Displays defrost and hot start. Displayed by receiver unit LED.
Display “under centralized
control”
Displayed during centralized control. Not displayed, but you are warned by a
buzzer sound emitted from the
receiver unit .
Display “changeover under
control”
Displayed when cool/heat mode
cannot be switched.
Not displayed (you are warned by a
buzzer sound when the mode cannot
be switched).
Thermostat sensor in remote
controller
Equipped Not equipped
Ventilation mode Equipped Not equipped
SI-05C.BOOK Page 80 Monday, November 6, 2000 4:13 PM
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
