Test Operation SiE-05C
56 Test Operation Inverter K Series
1 Service monitor <HAP>
(Green)
Normal ................ Flicker
Malfunction ......... On or off
2 Function setting switch or LED
LED display
8
: On
9
: Flicker
7
: Off
Mode button ......... Mode change
•
Set return button .......... Changes or enters address or data.
•
Wiring check button .... Push and hold for 5 sec. to start wiring check.
•
Reset button ................. Push and hold for 5 sec. if the indoor unit’s PC board has been replaced, or
there has been a change in the combination of indoor and outdoor units, such as indoor unit extension,
etc.
3 Jumper pin Forced defrost operation by short circuit.
Setting mode 1
(H1P off)
Push 1 time.
Monitor mode
(H1P flickers)
Push 1 time.
Push and hold for 5 sec.
Setting mode 2
(H1P on)
Push 1 time.
(VF014)
BLAUW
M
D
S
X26A
(VL015)
Part3.fm Page 56 Wednesday, January 31, 2001 8:52 AM
Все каталоги и инструкции здесь: http://splitoff.ru/tehn-doc.html
To Next Page
Loading...
