Installation Guide
TG-0259_9 TM4 CO200-A3 Installation Guide
© Dana TM4 inc., 2020-2022
4 Installing the MCU in the vehicle
The following sections describe how to install the MCU in a vehicle. The final installation sequence should
be defined by the integrator as it depends on the type of application.
Read these general safety warnings before installation.
WARNING Mishandling of this product may damage the product and/or cause injury or death.
• All limitations and specifications communicated by Dana TM4 regarding the product must be
respected.
• Do not attempt to open, repair or modify the MCU. In case of damaged casing or suspected product
malfunction, contact Dana TM4 Customer Service.
• If using chains, straps or other lifting tools, ensure they do not touch or put pressure on any part of the
product exterior (surface, connectors, and/or cables).
4.1 Planning to install the MCU
• Ensure that everyone coming into contact with the MCU has received full training and has read all the
safety warnings in this guide.
• Follow all instructions in this guide on how to lift and install the MCU.
• Call Dana TM4 Customer Service if in doubt (see Section 5 for contact details).
4.1.1 Respecting CSC and MKC markings on interface drawings
Before installing the product, refer to any CSC and MKC markings on the product interface drawing [8].
These markings highlight areas that may potentially impact product safety, operation or longevity if proper
instructions are not followed:
• CSC is used to indicate Critical/Safety Characteristics with specific instructions that must be followed in
order to avoid potentially dangerous, hazardous or non-regulatory situations.
• MKC is used to indicate Major Key Characteristics with specific instructions that must be followed in
order to avoid major inconvenience to the user. Items marked with MKC do not, however, represent a
hazard in terms of operational safety.
4.2 Preventing damage to the MCU
These subsections give information on how to prevent damage to the MCU.
WARNING Mishandling of these products may damage the product and/or cause injury or death.
When manipulating and/or installing this product:
• Ensure that the MCU and the motor are attached to separate supports or brackets.
• Do not modify any part of the MCU.
• Do not apply any external load to the casing of the MCU.
To Next Page
